Hood Dryers & Hair Processors

TW-T3025AS2-H hair dryer with 7 color lights for Wall Mounting

Hair drying
Hair setting
Hair-care
Permanent wave
Hair-dyeing
7 Motive lights: White, Orange, Red, Yellow, Blue, Green, Purple

Made in Taiwan

Power: 1100W

Korea

Italy

Roller ball

Infrared Accelerator

Hair Heater Accelerator

CREATE Swing Touch 3D
(Thermal Processor)

Swing Touch 3D represents the new generation of hair processors. Redesigned from the ground up, the Swing Touch 3D boasts carbon fibre heat up, optimised wing span and and sophisticated position sensors to enhance coloring and perming treatments.

Features:

1. Advanced carbon fibre heater: Compared to conventional ceramic heaters, the carbon fibre heater allows super fast heat up and emits large amounts of far & near infrared rays to enable deep penetration of color and enhance perming outcomes
2. Intense reflection plate: Anodised aluminium plate increases surface strength and intensifies heat reflection.
3. Optimised wing span: Minimises heat dissipation and enables close delivery of heat
4. Carbon tip :Enhances connectivity and reduces abrasion in rotation, increasing durability
5. Position sensors: Maintains wing alignment and finishes rotation with longer downward span
6. Increased safety & prevention: Rotation of wing span pauses when it is blocked
7. Finger touch digital panel
8. Manual mode for local heating: It can be manually paused if to apply heat on localised area of the hair with one or two heaters.
9. Anti-swing structured lift: Square-shaped lift pipe prevents machine from swinging when changing height or moving the machine

Made in Korea
Voltage: 220V 60 Hz

CREATE Swing Belle Hair Processor Setting Machine on Stand or for Wall Mounting

Swing Belle will replace the infrared device, hood dryer and Ozone devices all in one. This multi-functionality results in effective colouring, perming, hair conditioning or treatment.

• One-touch Digital Controller
• Ceramic Cap
• Temperature Perception Sensor
• 220V / 60Hz / 700W

CN-DLH177-FS Butterfly Hair Processor Setter on Stand
CN-DLW177-H Butterfly Hair Processor Setter for Wall Mounting

This hair drying machine has an innovative design comprising of two arch-shaped swing heaters which move in a gentle motion. The heaters envelope the head area, allowing the deepest conditioning and even colour acceleration. The double swing heater system maximises utilisation of short and long infrared waves to increase efficiency. That is often referred to as smooth and relaxing, while at the same time provides effective treatment of hair that is damaged by perm and colouring.

Directions of use: Drying machine should be adjusted and placed 4-6cm at the two arch-shaped heater from the top of head and 5cm at the position guide from rear of the neck. Turn on the power switch. Select the operation mode desired and adjust the heat level and time. Press the start key, then the circular heater will rotate. When the operation time is up, cool air will release from the nape fan. Turn off the power switch after use.